Descargar Imprimir esta página

How To Start The Engine; How To Stop The Engine - Briggs & Stratton 600 Serie Manual Del Operario

Ocultar thumbs Ver también para 600 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Add Fuel
Gasoline and its vapors are extremely
flammable and explosive.
Fire or explosion can cause severe burns
or death.
• Turn engine off and let engine cool at least 2 minutes
before removing the gas cap.
• Fill fuel tank outdoors or in well-ventilated area.
• If fuel spills, wait until it evaporates before starting
engine.

How To Start The Engine

CAUTION
This engine was shipped from the factory without oil. If
you start the engine without oil, the engine will be
damaged beyond repair and will not be covered under
warranty.
1. Check the engine oil.
2. When starting a new engine for the first time, firmly push
the primer bulb (D) five times. Then for all future starts,
push the primer bulb three times (Figure 3).
Note: Priming is usually unnecessary when restarting a
warm engine. However, cool weather may require
priming. If you push the primer bulb too many times, the
engine may flood with fuel and will not start.
D
Figure 3: Primer Bulb
3. If the product has a handle or a control panel equipped
with an engine brake release lever, engage the brake
release lever (E) as shown in Figure 4.
Figure 4: Engine Brake Release Lever
4. Firmly hold the starter rope handle (G). Slowly pull the
starter rope handle until resistance is felt, then pull
quickly (Figure 5).
8
WARNING
E
1. Remove the gas cap (Figure 2). Fill the fuel tank (B) to
approximately 1-1 / 2 inches below top of neck to allow
for fuel expansion. Be careful, do not overfill.
2. Replace the gas cap (A) before starting the engine.
B
A
Figure 2: Gas Cap
Rapid retraction of starter cord (kickback) will
pull hand and arm toward engine faster than
you can let go.
Broken bones, fractures, bruises or sprains
could result.
• When starting the engine, pull the starter rope handle
slowly until resistance is felt, then pull rapidly.
G
Figure 5: Starter Rope Handle
5. If the engine does not start after three pulls, push the
primer bulb three times and again pull the starter rope
handle. See the Troubleshooting page.

How To Stop The Engine

Release the brake release lever (F) as shown in Figure 6.
Figure 6: Engine Brake Release Lever
WARNING
F
BRIGGSandSTRATTON.com

Publicidad

loading

Este manual también es adecuado para:

120000