Important Notes; Maintaining Your Touch Display; Touch Sensor Care And Cleaning - 3M Multi-Touch C2167PW Guia Del Usuario

3
Intended Use
The 3M™ Touch Systems Touch Displays are designed for touch input and tested to
replace an existing display. These displays are intended for professional installation and
use in an indoor environment. They are not designed or tested for use in hazardous
locations. Use in any other application has not been evaluated by 3M and may lead to
an unsafe condition.

Important Notes

 In extreme temperature and humidity situations, you may observe condensation
between the touch screen and the display. To minimize this condition, place the unit
where it will be used and allow a 24-hour environmental stabilization period prior to
powering on the display. Any noticeable condensation is temporary and will have no
long term affect on the operation of the display.
 When unplugging power supply cord, hold the plug, do not pull by the cord.
 Do not connect or disconnect this product during an electrical storm.
 Install the display in a well-ventilated area. Always maintain adequate ventilation to protect the
display from overheating and to ensure reliable and continued operation.
 Do not expose this display to direct sunlight or heat. Passive heat may cause damage to the
housing and other parts.
 An inherent characteristic of the PCT sensor is a fine grid pattern that may be visible under
certain lighting conditions.
 Do not install this display in areas where extreme vibrations may be generated. For example,
nearby manufacturing equipment may produce strong vibrations. The vibrations may cause the
display to exhibit picture discoloration or poor video quality.
 The 3M touch controllers mentioned in this document, are USB compatible full speed
devices.
 3M does not warrant that we are USB compliant pursuant to USB specifications.

Maintaining Your Touch Display

To maintain your display and keep your display operating at peak performance:
 Keep your display and touch sensor clean.
 Adjust the display video controls.
 Do not install the display in a place where ventilation may be hindered.

Touch Sensor Care and Cleaning

3M Touch Systems recommends that you periodically clean the glass touch sensor
surface. Be sure to turn off your display before cleaning.
Typically, an isopropyl alcohol and water solution ratio of 50:50 is the best cleaning
agent for your touch sensor.
3M Touch Systems, Inc. Proprietary Information –
3M™ Multi-Touch Display User Guide
TSD-44310 REV C