Faucet Installation - Price Pfister Falsetto 49 Serie Manual Del Usuario

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes
NOTE: If installation surface depth is thicker than 1
number 971-026.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE Plumber's Tape • Plumber's putty
• Adjustable wrench • Pliers
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4
B
N
D
F
M
C
E
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Spout B Handles (2x)
D Pop-Up Rod E Pop-Up Assembly
G Mounting Washer H Hose
K Square Washer (2x) L Locknut
N Valve Adapters (2x)
If any of these items are missing, please contact Price Pfister Consumer Service at
1-800-Pfaucet (1-800-732-8238).
1
/ ", order spare part
2
• Slotted screwdriver
• Flashlight
A
B
N
F
F
C
G
L
K
J
H
C Valve Bodies (2x)
F Seal Rings (3x)
J Mounting Nuts (2x)
M Aerator Tool
ENGLISH

FAUCET INSTALLATION

5
5A
5 SPOUT ATTACHMENT
Insert Lift Rod (5A) into hole at the back of Spout (5B). Place Plastic Seal Ring (5C)
against the bottom of Spout Body (5D). With Spout (5E) facing forward, carefully install
the Lift Rod (5A), and receiving Tube (5F) through the center hole of sink (5G).
6
6 SPOUT BODY INSTALLATION
From underneath sink, secure Spout Body (6A) by placing Metal Washer (6B) and
threading Locknut (6C) onto Mounting Post (6D). Make sure that the bumps on Metal
Washer (6B) are facing up.
Caution: Do not over tighten!
2
5E
5B
5F
5G
6A
6D
6B
6C
5D
5C