Memory Deletion; Additional Information - Nice Neomat A Instrucciones Y Advertencias Para La Instalación Y El Uso

Table "A11" Changing the activation level of the "sun" automation
Press and hold down button ■ of a previously memorized transmitter until you hear a
1.
beep (after about 5 seconds) then release it.
Slowly press button t the same number of times (1, 2, 3, 4 or 5) as the desired level
2.
3. After a few moments you will hear a number of beeps equal to the required level
Press and release button ■ to confirm
4.
If at point 3 you don't here the number of beeps equal to the desired level, simply do not press anymore buttons and wait a few seconds for
it to finish without changing the level.

4.4) Memory deletion

If you need to delete all the transmitter and the programmed operations, carry out the procedure shown in table A12.
The memory can be deleted:
• with a non-memorized transmitter starting from point A.
• with a previously memorized transmitter starting from point No. 1.
The following can be deleted:
• only the memorized transmitters, finishing at point No. 4
• all data (transmitters, sensor level, TTBUS address, etc.), completing the procedure until point 6.
Table "A12" Memory deletion
Ë
A. Switch the motor off, activate the Step-by-Step input (by connecting the White cable
with the White/Black one) and keep it active until the end of the procedure
B. Power the motor and wait for the initial beeps
Ë Press and hold down button ■ on a transmitter (about 5 seconds) until you hear
1.
a beep; then release it
Hold down the s button on the transmitter until you hear 3 beeps;
2.
release the s button exactly during the third beep
Hold down button ■ on the transmitter until you hear 3 beeps;
3.
release button ■ exactly during the third beep
Ë Hold down the t button on the transmitter until you hear 3 beeps;
4.
release the t button exactly during the third beep.
5. To cancel everything:
Press both s and t within 2 seconds
Cancellation is confirmed by releasing buttons s and t on the first of the 5 beeps
6.

5) Additional information

The NEOMAT-A motors recognise other ERGO, PLANO, NICEWAY and VOLO-S-RADIO series transmitters (see chapter 5.1 "Available trans-
mitters"). A particular command can also be associated to each transmitter button by means of a specific memorization procedure (see chap-
ter 5.2 "Transmitter programming in Mode I and Mode II").
Warning: use transmitters that have been memorised in Mode 1 only for programming.
5.1) Available transmitters
Table A13 indicates the transmitters that can be used.
Table "A13"
Transmitters
ERGO1 - ERGO4 - ERGO6
PLANO1 - PLANO4 - PLANO6 - PLANO TIME
VOLO-S-RADIO
NICEWAY (the whole series)
FLO1R - FLO2R - FLO4R
VERY VR
ERGO PLANO
FLO4R VERY
Example
5s
X1 = 5 Klux
X2 = 10 Klux
X3 = 15 Klux
X4 = 30 Klux
X5 = 45 Klux
X1 = 5 Klux
X2 = 10 Klux
X3 = 15 Klux
X4 = 30 Klux
X5 = 45 Klux
Example
PP
5s
NICEWAY VOLO S RADIO
8