Würth POWERCUT 70S Traducción Del Manual De Instrucciones De Servicio Original página 26

• Make sure to turn off the power supply when dis­
mantling or installing any spare parts (such as
torch, electrode, nozzle, earth clamp or other
spare parts)
• Make sure to turn off the power supply when dis­
mantling or moving the machine.
• Never allow people with heart pace close to the
working site without the permission of the doctor.
The magnetic field produced by the cutters dur­
ing operation will cause negative affect to the
heart pace.
• The cutting cable can not be pressed or shocked
by any appliance.
• Never clean the slag in the torch head by violent
knocking.
Complete Set Specification
Complete Set Supply
• POWERCUT 70S: 1
• Cutting Torch: 1
• Nozzle (one in the torch): 3
• Electrode (one in the torch): 3
• Earth Cable with clamp: 1
• Product Certificate:1
• Operator's Manual: 1
Notice:
a) No guarantee has been made yet to get the
accessories repaired at any time because of its
breakable attribute.
b) The accessories for manual or automatic round
cutting should be equipped separately.
c) If there is any stipulation in the contract, then
base on the contract.
Service, Maintenance,
Transportation and Storage
The welder needs regular maintenance as following:
Periodically clean dust, dirt, grease, etc. from your
welder. Every six months, or when necessary, remove
the welder cover panel and air­blow any dust and
dirt that may have accumulated inside the welder.
Replace power cord, ground cable, ground clamp,
or electrode assembly when damaged or worn.
MINOR AND ROUTINE MAINTENANCE
Store in a clean dry facility, free from corro­
sive gas, excess dust and high humidity. Temperature
range should be ­12°C to +50°C and the relative
humidity not more than 90%.
When transporting or storing the welder after use,
it is recommended to repack the product as it was
received in order to protect it. (Cleaning is required
before storage and you need to seal the plastic bag
in the cardboard box before storage).
Guarantee
For this Würth power tool, we provide a guarantee
in accordance with the legal/country-specific regu­
lations from the date of purchase (verified by invoice
or delivery document). Damage that has occurred
will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the power tool is
sent undisassembled to a Würth branch office, your
Würth sales representative or a customer service
agent for Würth power tools.
Disposal
The machine, accessories and packaging
should be sorted for environmental­friendly
recycling.
Do not dispose of power tools
into household waste!
Only for EC countries:
According to the European Guideline 2012/19/EU,
power tools that are no longer usable, and accord­
ing to the European Guideline 2006/66/EC,
defective or used battery packs/batteries, must be
collected separately and disposed of in an environ­
mentally correct manner.
EC Declaration of Conformity
We declare under our sole responsibility that this
product is in conformity with the following standards
and standardization documents:
EN IEC 60974-1: 2018, EN 60974-10:2014
in accordance with the directives: 2014/35/EU,
2014/30/EU.
26