Sanus Systems MC1A Manual De Instrucciones página 9

CAUTION:
Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage:
 Pilot holes MUST be drilled to a depth of 63.5 mm (2.5 in.), using a 5.5 mm (7/32 in.) diameter drill bit.
 DO NOT over-tighten the lag bolts [05].
 Any material covering the wall must not exceed 16 mm (5/8 in.).
Wood Joist Ceiling Mounting
1. Locate joist. Verify the center of the joist with an awl or thin nail or use
an edge to edge joist fi nder.
2. Align the ceiling plate [01] and mark the hole locations.
3. Drill pilot holes as illustrated.
4. Tighten the lag bolts [05] only until the washers [06] are pulled fi rmly
against the ceiling plate [01].
2
4
(6901-002094 <00>)
13mm
5.5 mm
(1/2 in.)
(7/32 in.)
CAUTION:
[01]
[06]
[05]
1
< 16 mm
(5/8 in.)
3
2
63.5 mm
2.5 in.
9