Publicidad
Idiomas disponibles
Idiomas disponibles
Taking all under car safety precautions, lift the vehicle using a hoist or hydraulic lift. Once this has been done, you may begin
working on the exhaust system.
1. Brace Removal: For convertible vehicles, it is recommended that you remove the underbody bracing before replacing the
accessory exhaust. Remove the braces in the order shown. Retain all fasteners for re-installation.
2. Stock Exhaust Cut Location: Raise the vehicle so that the center and rear section (1) of the factory exhaust can be reached.
Cut the exhaust at the tangent point (2).
3. Rear support bracket (LH shown, RH similar): Remove the factory muffler from the hangers. Unbolt and retain the nuts (1)
from the support brackets near both tailpipes at the rear of the vehicle and remove the support brackets from both sides as
shown.
Chevrolet Performance Exhaust –
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
Production Exhaust System Removal
Gen 6 Camaro 4 Cylinder (LTG)
84578425
IR 22MY18
PART NO.
DATE
22MY18
Initial Release - Benjamin Kaminsky
3
SHEET
REVISION
21
OF
AUTH
N/A
Publicidad
