Publicidad
Idiomas disponibles
Idiomas disponibles
10. Support bracket nut locations: Once tip is aligned fore/aft, tighten two nuts (1) on rear support bracket as shown. Torque
nuts to 40 Nm (30 lb ft). Repeat for opposite side.
Note: Make sure two areas indicated (1) do not overlap when tightening.
11. Check orientation of all clamps. Notch (1) on pipes should not align with open area of band clamp. Clamp bolt should not be
located on the bottom of the exhaust pipe.
12. Clamp locations: Starting at the front and working rearward, tighten the clamps (1) to 45 Nm (33 lb ft).
13. After tightening confirm exhaust tip is still properly aligned both fore/aft and centered in the opening. If it has shifted, loosen
the appropriate clamp(s) and readjust.
Chevrolet Performance Exhaust –
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
Gen 6 Camaro 4 Cylinder (LTG)
84578425
IR 22MY18
PART NO.
DATE
22MY18
Initial Release - Benjamin Kaminsky
6
SHEET
REVISION
21
OF
AUTH
N/A
Publicidad
