Publicidad
Idiomas disponibles
Idiomas disponibles
7. Pre-installed Hardware on muffler: Install a hanger over the end of one of the new mufflers, and install respective rear support
bracket (1) onto muffler as shown.
Caution: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that
application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are
identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces
unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the
correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
8. Mounting locations for new mufflers: Seat muffler (1) on to end of pipe. Seat mid-hanger mount of muffler into rubber hanger
(2). Install rear support bracket (3) onto studs and hand tighten nuts.
9. Tip alignment looking straight up from below: Align tip fore/aft as shown. When looking straight up from the ground, outside
corner of tip will protrude from local opening further than the factory tip. It should still be under-flush to the rear fascia by
approximately one inch at the furthest outboard spot (1) (shown with arrow). If tip is too far forward in vehicle, damage to the
fascia can occur from the exhaust heat. If tip is too far rearward, tip may be too easy to contact when loading or unloading
trunk.
Note: If vehicle is equipped with the Body Accessory Trim Package (including rear ground effects), please refer to the
installation manual of that package for proper mating exhaust ring installation. In addition, if vehicle does have the Body
Accessory Trim Package (including rear ground effects), the Chevrolet Performance Exhaust kit without chrome tips should
be installed/utilized.
Chevrolet Performance Exhaust –
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
Gen 6 Camaro 4 Cylinder (LTG)
84578425
IR 22MY18
PART NO.
DATE
22MY18
Initial Release - Benjamin Kaminsky
5
SHEET
REVISION
21
OF
AUTH
N/A
Publicidad
