7.5.2 Cappuccino-maker wash
Use special care in cleaning the cappuccino maker,
following the procedures indicated below:
• do a first washing by immersing the suction tube in
water and run a delivery for a few seconds;
• turn the rotating body (X) 90° to position B (closure
of milk outlet duct);
• holding the milk suction tube in the air, dispense
steam (cappuccino maker dry run);
• wait about 20 seconds to allow for internal cleaning
and sterilisation of the cappuccino maker;
• close the steam and put the rotating body back in
position A;
• if the air intake hole (Y) is blocked, clear it gently
with a pin.
Position A
X
Clean the cappuccino maker after each continuous use and at
least once a day.
7.5.3 Filter and filter-holder cleaning
Daily:
• Soak the filter and filter-holder in hot water overnight
so that the fatty coffee deposits can dissolve;
• rinse with lukewarm
water.
Weekly:
• Use a screwdriver to de-
tach the filter from the
filter holder;
• Soak the filter and filter
holder in warm water and cleaning agent for 10
minutes.
• rinse with lukewarm water.
Caution: Only immerse the filter holder cup, avoid soaking the
handle in water.
The detergent must be diluted in cold water in the doses indicated
on the package (see manufacturer).
70
260
of
Y
Position B
7.5.4 Washing of dispensing unit AEP version
Wash the dispensing units daily, as instructed here-
under:
• Remove the fil-
ter from the filter
carrier, and fit a
blind filter (see
spare parts);
• pour the specific
detergent (see
spares) in the fil-
ter carrier with blind filter
and hook to the dispensing
unit;
• carry out some dispensing
cycles until clean water will
flow out of the drain;
• remove the filter carrier from
the unit and carry out at least
one dispensing cycle so as to eliminate the detergent
residue.
• remove the blind filter from the filter carrier replacing
it with the original one.
7.5.5 Washing of dispensing unit, SAE-DISPLAY version
Wash the dispensing units daily, as instructed here-
under:
• Remove the fil-
ter from the filter
carrier, and fit a
blind filter (see
spare parts);
• pour the specific
detergent (see
spares) in the fil-
ter carrier with blind filter
and hook to the dispensing
unit;
• on the keypad of the unit
to be washed, keep but-
ton 2 pressed for at least 10
seconds (the led of button 2
flashes);
1
2
3
PROG.
STOP
4
USER manual