Kit Assembly - Metra 95-6554B Instrucciones De Instalación

1. Secure the radio brackets to the radio
using screws supplied with the radio.
(Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
3. Slide the radio assembly into the dash,
then secure using :
a. The (2) factory climate control screws
down below. (Figure B)
b. The factory radio screw in the top right.
(Figure B)

KIT ASSEMBLY

(Figure A)
(Figure B)
4. Drill a 1/8" hole in the sub-dash at the
top left bracket area, then fully secure
the radio assembly using the Phillips
screw provided. (Figure B)
5. Attach the factory A/C vents to the
95-6554B radio trim panel. (Figure C)
6. Attach the factory panel clips to the
95-6554B radio trim panel, then clip the
panel onto the dash to complete the
installation. (Figure D)
(Figure C)
(Figure D)
REV. 8/6/2021 INST95-6554B
5