GE DPI 811 Manual De Usuario página 12

Example 2) Set up values for x:y Scaling = 0 to 100%.
Settings Settings
1
x:y
▲
▼
Sk1 = Edit
= Flow scaling (mA, pressure only)
Table 5: (Part of table) Menu options - Settings (Output)
Options Description
(If applicable)
... Units To select the temperature units (°C or °F).
... type To select an applicable RTD type (Pt50, Pt100 ... )
To select and set up a value for the "Nudge" output.
Example: 10°C increments.
Additional data: Select Settings (■ ■)
To select and set up values for the "Span Check"
output. Example output cycle:
Additional data (Table 6): Select Settings (■ ■)
To select and set up values for the "% Step" output.
% Step
Example output cycle:
Additional data (Table 6): Select Settings (■ ■)
To select and set up values for the "Defined Step"
... Step
output. Example output cycle:
Additional data (Table 6): Select Settings (■ ■)
K345 Issue 4
2 Edit
x:y
▲
■ ■ ▼
■ ■
This cycle repeats
automatically.
Auto Repeat - Optional
Auto Repeat - Optional
Table 5: (Part of table) Menu options - Settings (Output)
Options
3 4
(If applicable)
Table 6: Additional data for Settings (Output):
Item
Span Check
Low (0%)
High (100%)
Dwell (d)
% Step
Step Size (s)
... %
Defined Step
Step Size (s)
Ramp
Travel (t)
Auto Repeat
Description
To select and set up values for the "Ramp" output.
Example output cycle:
Auto Repeat - Optional
Additional data (Table 6): Select Settings (■ ■)
Value
Set the 0% value.
Set the 100% value.
Set the period (Hours:Minutes:Seconds) between
each change in value.
Low (0%), High (100%), Dwell (d): As above.
Set the change in value for each step as a
percentage of the full-scale range (High - Low).
Low (0%), High (100%), Dwell (d): As above.
Set the change in value for each step as a
temperature or resistance value.
Low (0%), High (100%), Dwell (d): As above.
Set the period (Hours:Minutes:Seconds) to go from
the Low (0%) value to the High (100%) value.
If applicable, select this item to repeat a cycle
continuously.
5
[EN] English -