Walimex Pro Light Shooter 360 TTL Manual De Instrucciones página 24

• FEB will be cancelled after three are taken.
• For best results, set the camera drive mode to „single" and ensure the flash
is ready before shooting.
• FEB can be used with FEC and FEL
• C.Fn You can prevent the FEB from being cancelled automatically three
photos are taken. (C.FN-FEB ACL, Page 56)
• C.Fn The FEB shooting sequence can be changed. (C.Fn-FEB, Page 56)
6.2.3 FEL / Flash Exposure Lock / Nur Canon
• Saving the flash exposure sets the correct flash for a desired part of the
subject.
• To do this, press the <FEL> button (if there
isn't one, use the <*> button) if <ETTL> appe-
ars on the LCD display.
• 1. Focus on the subject.
• 2. Press the <FEL> button.
• Keep the middle of the view-finder on the
subject and press the <FEL> button.
• The flash will trigger a pre-flash to take a measurement and the required
flash power for the subject will be set.
• Each time the <FEL> button is pressed, a pre-flash is triggered and the new
flash power will be saved.
• If the subject is too far away and is underexposed, <
view finder. Go closer to the subject and use the flash exposure lock (FEL)
again.
• If <ETTL> is not shown on the LCD display, the FEL function cannot be
used.
46
6.2.4 High-Speed Sync - Only in E-TTL / i-TTL and Manual modes -
With the high-speed synch function, you can use the flash with all shutter
speeds.
• Press function button 4 until the display shows the symbol <
• To exit this mode, press the button again.
• If you set a shutter speed that matches or is slower than the maximum flash
• If during high-speed synch, you select a faster shutter speed, the effective
• In high-speed synch mode, the <MULTI> (strobe) function is not available.
• After 30 consecutive flashes in this mode, the overheat protection function
6.2.5 Second Curtain Sync - Only in E-TTL / i-TTL and Manual modes -
> will flash in the
Use this function for slow shutter speeds. In this setting, the flash will be trigge-
red just before the shutter is closed.
This means you can illuminate areas outside the flash range for longer.
The flash will then light up objects within its range and freeze movement.
• Press function button 4 until the display shows the <
• To exit this mode, press the button again.
synch time, < > will not be displayed in the view finder.
flash area will be reduced.
may be activated.
>.
> symbol.
47