Würth 1952 003 390 Traducción Del Manual De Instrucciones De Servicio Original página 11

DE
GB
INTRODUCTION
FR
It is compulsory to read this instruction manual before starting any
kind of action.
NL
The proper operation and full compliance of this product's
performance is guaranteed only if all the instructions provided in this
ES
manual are closely adhered to.
We guarantee that this product complies with the technical
IT
specifications described in this manual.
The manufacturer shall not be held responsible for any improper
uses other than those described herein.
PT
Use protective work gloves, protective footwear, hard hat and safety
goggles.
PL
Misuse:
- This product should only be used as described in this
DA
documentation; any other use is considered improper.
- The manufacturer accepts no responsibility for any
damage caused by the incorrect or unreasonable use of
EL
the equipment.
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
WARNINGS:
This tool set should be used by experienced
personnel only
Do not use it with a pneumatic screwdriver
At least the following PPE should be worn when
using the tool set
DESCRIPTION
This tool set is a PATENTED solution for removing and refitting
modern hubs with integrated bearing type HBU2 (a pre-assembled
unit combining hub and bearing, i.e. the Hub Bearing Unit).
This tool set can be used directly on the car, without having to
disassemble the king pin/hub/bearing unit from the car and placing
it on a press.
METHOD OF PREPARATION
1
2
3
Discharge groove
Hub bearing
C B
A
E
G
Hbu type hub-bearing to be
replaced like this, already
assembled.
The insertion thrust should take
place in the bearing's outer
groove so as not to compromise
its operation or break it.
D
F
11