How To Use The Memory Function; To Delete All Values Stored In The Memory - Medel ELITE Instrucciones De Uso

EN
Further information
Measurements should not occur soon after each other, since otherwise, the results
will be falsified. Wait the before for 2-3 minutes in a relaxed position, sitting or
lying, before you repeat a measurement.

5.4 How to use the memory function:

• In Clock mode ( Off mode) , press MEM button. The number of stored data
is showed (pic14), sudden the latest result will be displayed with date and
time (pic15).
• Press MEM button repeatedly to review the results measured .
• Press T3 button, the average value of the last 3 measurements will be dis-
played, with AVG symbol blinking. (pic.16) .
• To display stored data press again MEM button.
NOTE:
When displaying the stored results, the monitor will turn off automatically after 2
minutes of no operation. You can also press the button O/I to turn off the display
manually.

5.5 To delete all values stored in the memory:

In Clock mode ( Off mode) press MEM button , after the latest data stored will be
displayed press again and hold MEM button for 3 sec. All results will be deleted
display. Press the button MEM or O/I, the display will turn off. (pic.17)
6. ERROR MESSAGE/MALFUNCTION
If an error occurs during measurement, the operation is discontinued; an error
code is displayed. (pic.13) Follow the below recommended actions and press
O/I button again to initiate another measurement.
Error code
Er 0
Er 1
Er 2
Er 3
16
Possible cause(s)
Pressure system is unstable
before measurement
Fail to detect systolic pressure
Fail to detect diastolic pressure
Pneumatic system blocked or
cuff is too tight during inflation
Recommended Action
Don't move and try again.
Apply the cuff correctly and try
again