Organizational Measures - SCANMASKIN SCAN COMBIFLEX 500I Manual De Instrucciones

SCAN COMBIFLEX 500i/500PD
2.3

Organizational measures

The user guide is to be kept near the location where the machine is being operated and
must be within reach at all times.
In addition to this user guide general and legal regulations regarding accident prevention
and environmental protection must be complied with as per local regulations.
Such duties may, for example, relate to the handling of hazardous substances, or to the
provision and wearing of personal protection equipment, as well as compliance with traffic
regulations.
The user guide must be supplemented by other instructions, including the duty to super-
vise and report incidents relating to particular working practices, for example work organi-
zation, work procedures and personnel safety.
Personnel entrusted with working with the machine must read the User Guide before
starting work, in particular the "2 Safety Regulations" chapter. To read these instructions
after work is commenced is too late. This particularly applies to incidental activities such as
setting up the equipment, carrying out maintenance work or training staff to work with the
machine.
From time to time the working practices of the operators are to be checked by a supervi-
sor especially to the items regarding awareness of safety and hazards.
Operators must tie back long hair, and not wear loose clothing or jewelery including rings.
There is a risk of injury through items getting caught, or being drawn into moving machin-
ery.
Eye and ear protection must be worn at all times!
Use personnel protection equipment if necessary or required by local regulations! Take
notice of all safety and hazard notices on the machine!
All safety and hazard notices at or on the machine must be kept complete and legible!
If safety-critical changes occur to the machine or its working method, the machine must be
shut down immediately! The cause of the fault must be established, and rectified.
Changes, add-ons or conversation to the machine, which might impair safety, must not be
made, without the manufacturer's permission!
This applies in particular to the fitting and adjustment of safety devices.
Spare parts must comply with the technical requirements specified by the manufacturer.
This is always guaranteed if original spare parts are used.
Intervals for recurring checks and inspections specified in this User Guide must be com-
plied with!
www.scanmaskin.com
ENGLISH
51