Master Trimmers MT Standard 50 Manual De Uso Y Mantenimiento página 27

Maintenance
IMPORTANT: Maintenance work must always be done with the machine stopped and with the electrical connector
disconnected. Always wear protective gloves for maintenance operations.
To obtain a nominal amount of product and make efficient use of the machine, it must be cleaned regularly. The
intensity and frequency of the cleaning will depend on the conditions of the incoming raw material. Master Products
recommends cleaning the rack and blades at least once every 4 hours of operation. For optimal cleaning, use hot
water and Master Clean liquid. We recommend cleaning and sanitizing the other parts of the machine at the end of
each working day (8-12 hours).
NOTE:
Sharpen the blades when cutting efficiency decreases.
For a finer cut, we recommend spraying the blades with vegetable oil once the cleaning operations are finished.
Cleaning the blades and the grid
Warning: To carry out this operation, it is essential to wear protective gloves and follow the safety recommenda-
tions since you will be working in direct contact with the blades.
Press the ON/OFF switch on the machine to turn it off and discon-
1
nect it from the power source. IMPORTANT: The machine must
be stopped and disconnected before manipulating it.
Unscrew and remove the bolts that link the blades to the motor
3
shaft using Allen key No. 4 (K). Then remove the blades. IMPOR-
TANT: The machine must be stopped and disconnected
before manipulating it.
Thoroughly clean the grid by spraying with water, preferably hot, or Master Clean liquid. Take advantage of the current layout of the machine
5
to clean the interior area. For a finer cut, after cleaning we recommend spraying the blades with vegetable oil.
Open the four latches of the grid to remove it and access the
2
blades.
Proceed with cleaning/preventive maintenance operations. Hold
4
the blades in the centre to avoid being cut. It is very important to
remove the embedded material at the bottom of the blades. The
accumulation of raw material debris in this area drastically reduces
the cutting efficiency of the blades.
www.masterproducts.es
27