Master Trimmers MT Standard 50 Manual De Uso Y Mantenimiento página 29

Loosen, without removing, the two side screws shown in the
5
following image using the fixed spanned No. 13, and repeat the
same process with the two screws on the opposite side.
Place the protection grid and fix it with the help of the four latches.
7
Screw in or unscrew the threaded studs to raise or lower the
blades as required.
Once the blades are level, remove the grill and fix the two side
8
screws on both sides with the help of the fixed spanner No.13, as
shown in the following image.
Finally, replace the protection grid and fasten it with the help of the four latches.
10
The red coloured support in the following image is now released
6
and is free to move. Screwing or unscrewing the four threaded
studs on it and enabled for this purpose allow the blades to
be levelled, but before doing that, the grid must be placed as
described in the next step.
Measure the distance between the two ends of the blades and the
grid with a caliper or other measuring instrument as shown in the
following image.
=
If the distance is not the same, it will be necessary to adjust the height,
screwing or unscrewing the threaded studs, as appropriate.
Next, tighten the four nuts shown in the following image, using the
9
Allen key No. 3 (J) and fixed spanner No. 10.
www.masterproducts.es
=
29