Cleaning The Blades And The Grid - Master Trimmers MT Gentle 50 Manual De Uso Y Mantenimiento

Maintenance
IMPORTANT: Maintenance work must always be done with the machine stopped and with the electricity supply
disconnected. Always wear protective gloves for maintenance operations.
To obtain a nominal amount of product and make efficient use of the machine, it must be cleaned regularly. The
intensity and frequency of the washes will depend on the conditions of the raw material input. Master Products
recommends washing the rack and blades at least once every 4 hours of operation. For optimal cleaning, use hot
water and Master Clean liquid. We recommend washing and sanitizing the other parts of the machine at the end of
each working day (8-12 h).
NOTE: Sharpen the blades when cutting efficiency decreases.
For a finer cut, we recommend spraying the blade of the knives with vegetable oil once the cleaning operations are
finished.

Cleaning the blades and the grid

Warning: To carry out this operation, it is essential to wear protective gloves and follow the safety recommendations
since you will be working in direct contact with the blades.
First, press the ON/OFF switches on the machine to turn it off.
1
Then disconnect it from the electricity supply by unplugging
it. IMPORTANT: The machine must be stopped and
disconnected before manipulating it.
Open the four latches of the grid to remove it and access the
3
blades.
Proceed with cleaning and/or maintenance operations. Hold
5
the blades in the centre to avoid being cut. It is very important
to remove the embedded material at the bottom of the blades.
The accumulation of raw material debris in this area drastically
reduces the cutting efficiency of the blades.
30
Loosen the two retaining knobs (G) that fix the container to the
2
body of the machine. Then disconnect the motor cable of the
container from the power input located on the side of the machine
body. Remove the container.
Unscrew and remove the bolts that link the blades to the
4
motor shaft using Allen key No. 4 (P). Then remove the
blades. IMPORTANT: The machine must be stopped and
disconnected before manipulating it.
Thoroughly clean the grid by spraying with water, preferably
6
hot, or Master Clean liquid. Take advantage of the condition
of the machine to clean the interior area. For a finer cut,
after cleaning we recommend spraying the blades with
vegetable oil.
www.masterproducts.es