Beem Classico Manual De Instrucciones página 135

EN
2. Set up the device in a suitable location, following the safety instructions and the
notes provided at the beginning of this chapter.
3. Completely unwind the mains cable and plug into a properly installed plug socket
that is easily accessible.
4. Before you enjoy your fi rst coffee, we recommend that you carry out a trial run with
coffee powder to remove any possible production residues in the water system
and in the milk tank system. To do this, follow the instructions in the "Handling and
Operation" and "Use" chapters.
When the device is fi rst used, production-related additives (e.g. grease) may cause
a small amount of smoke and / or an odour to be produced. This is normal and not
a device defect.
5. Perform this process twice. Caution! Do not drink this coff ee!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).
Handling and Operation
NOTES
• Do not pour milk or other liquids into the water tank. Only ever use water to make
coffee!
• Do not pour any liquids into the milk tank other than milk or if necessary water for
cleaning.
• Never overfi ll the portafi lter.
Inserting the Drip Tray
The device is supplied with a drip tray (10) as coffee might drip out of the coffee outlet
(14) or milk might drip out of the milk nozzle (8) after making coffee.
Only attach the drip tray to the device / remove it from the device when the milk
tank is not inserted in the device.
1. Place the cover (11) on the drip tray. Make sure that it fi ts correctly.
2. Place the drip tray on the surface and slide it into the device at the designated point.
Filling the Water Tank
1. Open the water tank lid (1).
2. Take out the water tank (2) by the handle.
3. Pour the quantity of water you want (note the MAX marking) into the water tank.
4. Reinsert the water tank and fl ip the handle down (Picture A). Make sure that the
water tank fi ts correctly.
03428_DE-EN-FR-NL_A5_V3.indb 30 03428_DE-EN-FR-NL_A5_V3.indb 30
30
12.01.2018 11:24:43 12.01.2018 11:24:43