Tabla de contenido
Publicidad
ELECTROMAGNETIC COMPATIBILITY TABLES
Guidance and manufacturer's declaration – ELECTROMAGNETIC EMISSIONS – FOR
The I-TECH UE device is intended for use in the electromagnetic environment
specified below. The customer or the user of the I-TECH UE should assures that it is
used in such an environment.
Emission test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations
/ flicker emissions
IEC 61000-3-3
Guidance and manufacturer's declaration – ELECTROMAGNETIC IMMUNITY – FOR
The I-TECH UE is intended for use in the electromagnetic environment specified
below. The customer or the user of the device should assure that it is used in such an
environment
Immunity test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
IACER Srl
ALL EQUIPMENT AND SYSTEMS
Compliance
Group 1
Class B
Class A
Compliant
ALL EQUIPMENT AND SYSTEMS
Test level
IEC 60601
±8kV in contact
±15kV on air
±2kV
for power
supplies lines
±1kV
for input/output
lines
56
Electromagnetic environment -
Guidance
The I-TECH UE device uses RF energy only
for its internal function. Therefore, its RF
emissions are very low and are not likely
to cause any interference in nearby
electronic equipment.
The I-TECH UE device is suitable for use
in
all
establishments
domestic and those directly connected
to the public low-voltage power supply
network that supplies buildings used for
domestic purposes.
Compliance level
±8kV in contact
±15kV on air
±2kV
for power
supplies lines
±1kV
for input/output
lines
other
than
Electromagnetic
environment -
guide
Floors should be
wood, concrete or
ceramic tile. If floors
are covered with
synthetic material,
the
relative
humidity should be
at least 30%.
Mains power quality
should be that of a
typical commercial
or
hospital
environment.
MNPG129-02
Publicidad
Tabla de contenido
