Proxxon BS/A Manual De Instrucciones página 13

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 30
1. Insert the plug of the charger.
2. Insert battery 1 in the charger 2 as shown
in Fig. 2.
3. The yellow light-emitting diode 3 signals the
charging process. When completed, the
green light-emitting diode 4 lights up.
4. Remove the completely charged battery
from the charger.
5. Insert battery 1 as shown in Fig. 3 in the
housing opening of the device until it engages.
To protect the battery from harmful total dischar-
ge while in operation, the charge status is per-
manently monitored electronically and the de-
vice will switch off before it reaches the critical
discharge condition. The battery will now need
to be recharged. Do not attempt to put the device
back into operation with a discharged battery!
6. To charge, press the release buttons 2, pull
out the battery to the rear and carry out
steps 1-5.
The charging process can be interrupted at
any time and continued without damage to
the battery.
Caution:
Drastically reduced operating times after the
charging process indicates that the battery
needs to be replaced!
If after inserting the battery into its designa-
ted opening the light-emitting diode fl ashes
instead of glowing yellow continuously, the
cause may be a too high temperature, a de-
fect, or the total discharge of the battery.
• If the battery is too hot, the charging process
will start automatically after it cools down.
• If, on the other hand, the battery has a nor
mal temperature but is totally discharged,
the charger will check if it still draws power
or it if is already defective.
• If the battery can be recovered, the yellow
light-emitting diode will glow continuously
after some time, signalling the successful
charging process.
• If the yellow light-emitting diode fl ashes, the
battery is defective and needs to be disposed
of; see also "Note on disposal within the EU"
later on in these instructions.
General handling of the device:
Caution!
Ensure the work piece is fi xed securely!
Loose work pieces should be clamped in a
suitable fi xture. This prevents the work pieces
from fl ying about
Danger!
Please wear a dust mask as necessary!
Some types of wood or even varnish residues
(or similar) can generate harmful dusts while
working. If you are unsure of the harmless-
ness of your material to be ground, please
wear a dust protection mask! Ensure the work
place is well ventilated in any case and work
with a vacuum cleaner for dust extraction as
necessary!
Hold power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring or its own cord. Cutting ac-
cessory contacting a "live" wire may make
exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Caution:
The battery must be removed from the device be-
fore assembly, adjustment (except the belt running
adjustment), maintenance measures or repair!
Connect the vacuum cleaner (Fig. 4)
We recommend to always work with the dust
extraction. Our "Compact Workshop Vacuum
Cleaner CW-matic" with automatic cut-off is
ideal for this use.
1. Put connection adapter 1 on the connecting
piece of the device
2. Put on the rubber connecting piece 2 and
insert the vacuum cleaner hose. The fl exible
- 13 -

Publicidad

Tabla de contenido
loading

Tabla de contenido