Technical Data; Noise/Vibration Information - Proxxon BS/A Manual De Instrucciones

1 Key (Fig. 1)
1. Rotational speed regulating knob with On/Off
switch
2. Battery
3. Battery release button
4. Adapter for dust extraction
5. Driving roller
6. Grinding head to belt guide
7. Stretcher
8. Tightening roller
9. Grinding belt
10. Adjusting screw for belt running
11. Locking button
12. Charger

2 Technical data

Dimensions, weight:
Length:
Weight:
Grinding belt length:
Head can be swivelled by 60°
Motor:
Voltage:
Band speed:
Noise generation:
LWA: 103 dB(A)
General measuring uncertainty: K=3dB
Grip vibration:

Noise/vibration information

The information on vibration and noise emis-
sion has been determined in compliance with
the prescribed standardised and normative
measuring methods and can be used to com-
pare electrical devices and tools with each
other.
These values also allow a preliminary evalua-
tion of the loads caused by vibration and noise
emissions.
approx. 330 mm
approx. 650 g
330 x 10 mm
10.8 V
200 to 700 m/min
LPA: 90 dB(A)
≤ 2.5 m/sec2
Warning!
Depending on the operating conditions while
operating the device, the actually occurring
emissions could differ from the values speci-
fi ed above!
Please bear in mind that the vibration and
noise emission can deviate from the values
given in these instructions, depending on the
conditions of use of the tool. Poorly maintai-
ned tools, inappropriate working methods,
different work pieces, too high a feed or unsu-
itable work pieces or materials or unsuitable
bits and cutters can signifi cantly increase the
vibration load and noise emission across the
entire work period.
To more accurately estimate the actual vibra-
tion and noise load, also take the times into
consideration where the device is switched
off, or is running but is not actually in use. This
can clearly reduce the vibration and noise load
across the entire work period.
Warning:
• Ensure regular and proper maintenance of
your tool
• Stop operation of the tool immediately if ex-
cessive vibration occurs!
• Unsuitable bits and cutters can cause ex-
cessive vibration and noises. Only use sui-
table bits and cutters!
• Take breaks if necessary when working with
the device!
Please note that the sound and vibration mea-
surements in particular have been performed
with Proxxon bits and cutters. When using
third-party brands we cannot guarantee com-
pliance with the statements given here!
Charger:
Mains voltage:
Output voltage:
Charging current:
100-240 V~50/60Hz
12.6 V
1 A
- 11 -