EN
Maintenance
Structure of Maintenance
chapter
The accompanying illustration sequences
must be followed while carrying out the
instructions provided in this chapter. Each
set of instructions refers to the accom-
panying illustration sequence.
Caring for and cleaning
smooth surfaces
All smooth surfaces can be cleaned hygien-
ically with water and a mild, liquid cleaning
agent that is kind to the skin.
ATTENTION
Surface damage caused by
aggressive and scouring
cleaning agents
▶ Never use cleaning agents
that contain chlorine or which
are acidic, abrasive or
corrosive.
Activating cleaning mode
• In cleaning mode, the flush actuation is
suppressed for 10 minutes. During this
time, you can clean the urinal or replace
the urinal trap.
• You can only activate cleaning mode
30 minutes after activating the power
supply or setting the flush time.
16
• You can also activate cleaning mode with
Geberit Clean Handy.
Prerequisite
–
Refer to illustration sequence
page 274 while carrying out the
instructions.
1
Hold a white sheet of paper in front
of the IR sensor on the bottom edge
of the urinal ceramic appliance for at
least 2 seconds.
2
Remove the white sheet of paper
after 2 short signal tones.
✓ The flush actuation is
deactivated and suppressed for
10 minutes. During this time,
you will hear a signal tone every
4 seconds.
3
Clean the urinal ceramic appliance
and replace the urinal trap.
Result
✓ Once 10 minutes have elapsed, a flush
is actuated.
Cleaning or replacing the
spray head
• Clean the cover for the spray head and
the nozzle with a mild, liquid cleaning
agent at least once a year.
• Descale the nozzle with a commercially
available descaling agent if necessary.
• Replace the nozzle if it can no longer be
completely cleaned and descaled.
Prerequisite
–
Refer to illustration sequence
page 277 while carrying out the
instructions.
1
Demount the urinal flush control to
disconnect the water supply. → See
illustration sequence
18014401623384843-1 © 09-2018
1
,
4
,
2
, page 275.
966.934.00.0 (02)