5
Step away from the urinal for at least
10 seconds so that the detection
range can be remeasured.
Result
✓ Once the procedure has been
completed, the flush will be actuated
and the detection distance will be set.
The urinal is ready for operation.
Replacing the batteries
Prerequisite
–
Refer to illustration sequence
page 283 while carrying out the
instructions.
–
2 replacement batteries (alkaline
batteries, 1.5 V, AA) are available.
1
Demount the urinal flush control. →
See illustration sequence
page 275.
2
Disconnect the cable for the battery
or rechargeable battery
compartment. → See illustration
sequence
9
, page 282.
3
Remove the battery compartment.
4
Open the cover, remove the
batteries and dispose of them.
5
Insert the replacement batteries.
6
Insert the battery compartment.
7
Plug in the cable for the battery or
rechargeable battery compartment.
→ See illustration sequence
page 282.
18014401623384843-1 © 09-2018
966.934.00.0 (02)
8
Result
✓ The urinal is ready for operation.
Charging the rechargeable
battery of the self-sustaining
power supply
If Geberit urinals with generator operation
are not used very often, the rechargeable
battery will not charge sufficiently. If a
11
,
signal tone sounds when you enter the
detection range, this indicates that the
rechargeable battery is almost empty. →
See "Troubleshooting", page 15.
1
2
,
2
3
4
5
10
,
Result
✓ The urinal is ready for operation.
Mount the urinal flush control. →
See illustration sequence
page 276.
Demount the urinal flush control. →
See illustration sequence
page 275.
Disconnect the cable for the battery
or rechargeable battery
compartment. → See illustration
sequence
9
, page 282.
Test and charge the rechargeable
battery with the battery charger (art.
no. 116.452.00.1). → See user
manual 965.861.00.0.
Plug in the cable for the battery or
rechargeable battery compartment.
→ See illustration sequence
page 282.
Mount the urinal flush control. →
See illustration sequence
page 276.
EN
3
,
2
,
10
,
3
,
19