Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SAVING THE VIDEOS (MAC OS)
1. Open the folder on your hard drive where you want to store the videos.
2. Go back to the folder view for the Micro-SD card storage and highlight all of the files you wish to save.
3. Click and drag the group of files to the folder on your hard drive where you want to store the files.
4. Once the files have transferred, you can delete the files on the Micro-SD card storage.
QUESTIONS AND TROUBLESHOOTING
For any questions or troubleshooting, you can refer to the Troubleshooting section starting at the bottom of page 9 in
the main product manual.
ADJUSTING THE LUX AND TIME DIALS
The video camera floodlight is factory set to record 10 seconds after motion stops. This is the recommended setting
to conserve video storage space on the Micro-SD card. If you want to increase the recording time and how long the
floodlight stays on at night, move the switch on the main body of the floodlight to the AUTO position and follow the
directions below.
Recording Duration Adjustment (TIME)
The TIME dial sets the duration that the unit remains activated after motion stops. The time period has an adjustable
range of 10 seconds to 1 minute. When it is dark enough, the floodlight is also controlled by the TIME dial.
•
To decrease the time period, move the dial toward the ( – ) symbol.
•
To increase the time period, move the dial toward the ( + ) symbol.
Test the time period by triggering the motion sensor at night and measure the time period the floodlight stays on. Adjust
the TIME dial until the desired duration is reached. The camera will stop recording at the same time the floodlight turns
off. During the day, only the camera will activate.
A shorter TIME setting will conserve battery life and storage space on the Micro-SD card. For best results, use the
shortest TIME setting for your location as possible.
Light Level Adjustment (LUX)
The LUX dial controls the amount of darkness needed for the motion sensor to be able to trigger the floodlight. It does
not impact the camera which will activate at all times, day or night, regardless of the floodlight. The video camera
floodlight is factory set to activate the floodlight when there is more daylight so the dial is set towards bright (). To
allow the floodlight to activate only after the sun has set, move the dial toward dark ().
Once you are done adjusting the dials, turn the switch on the main body to the OFF position. Re-attach the camera
module to the motion sensor.
Move the switch back to the AUTO position. Your video camera floodlight is now ready for use!
REPLACING THE MICRO-SD CARD
You may want to use more than one Micro-SD card or you may want to use a Micro-SD card with a different capacity.
To remove or replace the Micro-SD card:
1. Remove the camera module from the motion sensor.
2. Locate the sliding cover on the back of the camera module with a picture of a Micro-SD card.
10
All Rights Reserved.
Publicidad
Tabla de contenido
