Tools Required - MAXSA Innovations 44642-CAM-BK-16-12 Instrucciones De Montaje Y Funcionamiento

During the day, the camera will record everything in its field of view.
At night, the darkness makes it difficult to see objects more than
25 feet away even if the floodlight has activated. Because of this,
if the motion sensor is triggered by a moving object more than 25
feet away, the moving object may not appear on the video.
HOW TO INSTALL YOUR SOLAR SECURITY VIDEO CAM-
ERA AND FLOODLIGHT:
NOTE: INSTALL YOUR VIDEO CAMERA FLOODLIGHT IN A LOCATION WHERE YOU CAN ACCESS THE CAMERA MODULE.

Tools Required:

1. Phillips head screwdriver.
2. Drill, if you want to mount the video camera floodlight on harder surfaces like cement, concrete, or brick.
To Install The Solar Security Video Camera and Floodlight:
1. Align the video camera floodlight on the wall and mark the locations of the two mounting holes with a pencil.
2. If mounting on cement, concrete, or brick, drill pilot holes for masonry anchors. The masonry anchors are not
needed for mounting on wood.
3. Align the video camera floodlight on the wall and install the two screws using a screwdriver
4. Use the four (4) screws to mount the solar panel onto a solid surface following the same three steps above.
5. Adjust the angle of the solar panel by gently rotating the solar panel to a different locking position. Remember
to face the panel south for direct sunlight exposure. See the "Choosing A Location" section on page 2.
Fully charge the Solar Security Video Camera and Floodlight's battery pack.
1. Tightly connect the solar panel to the video camera floodlight power cable.
2. Ensure the power switch on the main body of your video camera floodlight is in the OFF position. In this
position, the solar panel will charge the battery during the daytime, but the unit will not activate.
3. Leave the switch in the OFF position for 3 days or longer before initial use to charge the battery pack fully.
NOTE: YOU MUST CHARGE THE VIDEO CAMERA FLOODLIGHT BEFORE MOVING ON TO THE NEXT STEPS. THE
CAMERA WILL NOT BE ABLE TO MAINTAIN AN ACCURATE DATE AND TIME IF THE VIDEO CAMERA FLOODLIGHT
HAS NOT BEEN CHARGED FOR MORE THAN FOUR (4) DAYS.
HOW TO DISCONNECT THE CAMERA MODULE/ACCESS THE DIALS
1. Hold the motion sensor by the sides. Be very careful not to put your fingers on the lens of the motion sensor
as doing so could damage the device.
2. Next, use your other hand to press the two gray buttons on both sides of the camera module to release the
module.
3. The camera module should separate directly away from the motion sensor.
4. There are two adjustment dials: TIME and LUX. These dials are located on the bottom of the motion sensor and
can be accessed once the camera module has been removed.
Motion Sensor Lens
1 2
Gray Button
3 4
Camera Module Bottom of motion sensor
with TIME and LUX dials.
3