Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Tips
Do not immerse the video camera floodlight in water or any other liquid.
Storage
If you wish to store your video camera floodlight indoors for more than two or three days, turn the power switch to the
OFF position. Battery capacity may be reduced during prolonged storage.
NOTE: THE DATE AND TIME ON THE CAMERA WILL SLIP IF MORE THAN 4 DAYS PASS WITHOUT CHARGING THE
VIDEO CAMERA FLOODLIGHT. WHEN YOU ARE READY TO USE THE VIDEO CAMERA FLOODLIGHT AGAIN, YOU
MUST FOLLOW ALL THE DIRECTIONS AS THOUGH YOU WERE SETTING UP THE VIDEO CAMERA FLOODLIGHT FOR
THE FIRST TIME. START WITH THE HOW TO INSTALL YOUR SOLAR SECURITY VIDEO CAMERA AND FLOODLIGHT
SECTION ON PAGE 3.
EXTENSION CORDS:
A 15-foot extension cord is available for the video camera floodlight for purchase for $14.95. This extension cord allows
the solar panel to be placed higher or further away from the video camera floodlight to ensure maximum direct sunlight
exposure.
TROUBLESHOOTING:
PROBLEM
I cannot see the
Sync Program on
my computer.
Computer wants to
format the disk.
When the camera
is plugged into the
computer, there are
no video folders in
the DCIM folder on
the Removeable
Disk.
Time and Date seem
wrong.
POSSIBLE SOLUTIONS
• The camera module may not be properly plugged-in. Remove the module and
then plug it back in.
• The micro-SD may not be installed properly. Follow the steps in the "Replacing
the Micro-SD Card" section on page 7 to re-install the micro-SD card properly.
• Make sure the video camera floodlight has been switched to the AUTO position.
• Make sure the camera module has been properly attached to the motion
sensor.
• Make sure the micro-SD card is installed properly and the rubber gasket
is in place. The back of the micro-SD little deeper into the camera module so it
is almost hard to hearing it click, take it out and try again.
• Be sure to leave the switch in the AUTO position for the duration of the light
cycle as turning it OFF before the end of the cycle will prevent the video(s)
from being stored.
• Make sure there have been multiple activations. When you first turn the video
camera floodlight on, it runs a test activation but does not record a video. It will
record all activations after the test activation.
• If the camera still does not store the videos, please contact for further
assistance.
• Remember to sync your camera whenever a time change occurs.
• If the date and time are off considerably, the battery pack may need to be
recharged. If the video camera floodlight has not charged for more than four (4)
days, it may cause a loss of accuracy. Turn the video camera floodlight off and
let it charge for 3 days while the camera module is plugged into the light. After
3 days, remove the camera module and sync it with your computer. Plug the
camera module back into the bottom of the motion sensor and move the switch
on the main body to the AUTO position. The date and time should be correct.
13
Publicidad
Tabla de contenido
