MAXSA Innovations 44642-CAM-BK-16-12 Instrucciones De Montaje Y Funcionamiento página 11

3. Use a Phillips-head screwdriver to remove the screw in the bottom of the cover, then slide the cover off the
camera module. You will see the back of the Micro-SD card.
4. Lightly press the Micro-SD card into the camera module until you hear a slight click. Then remove your finger
and the Micro-SD card should slowly spring back out of the module.
5. Grab the back end of the Micro-SD card with your fingertips and remove it from the camera module. To replace
the Micro-SD card, push it back into the slot on the back of the camera module. Be sure it is in the correct
orientation! This can be seen in the image below.
6. Once in place, lightly press the Micro-SD card into the camera module until you hear a slight click. Then release
your finger. The Micro-SD card should bounce back slightly, but still be firmly in place in the camera module.
NOTE: THE BACK OF THE MICRO-SD CARD SHOULD NOT BE FLUSH WITH THE GASKET. IT SHOULD BE SLIGHTLY
DEEPER INTO THE CAMERA MODULE SO IT IS ALMOST HARD TO TOUCH WITH YOUR FINGER. IF IT LOOKS FLUSH
WITH THE GASKET AFTER HEARING IT CLICK, TAKE IT OUT AND TRY AGAIN. IT MAY NOT RECORD PROPERLY IF IT
IS NOT INSERTED CORRECTLY.
7. Replace the sliding cover and put the screw back in the bottom of the cover with the screwdriver.
8. Reconnect the camera module to the motion sensor.
11