Kohler K-332 Manual De Instrucciones página 4

Apply
plumbers
putty.
2. Install the Showerhead
Remove the temporary nipple from the shower ell.
Apply a bead of plumbers putty or other sealant to the back of
the wall flange according to the manufacturer's instructions.
Slide the wall flange over the shower arm.
Apply thread sealant to the shower arm and thread it into the ell.
Use a clean strap wrench to securely tighten the shower arm.
Slide the wall flange tight against the wall and tighten the
setscrew.
Remove any excess plumbers putty.
Run hot and cold water through the shower arm to flush out dirt
and debris.
Apply thread sealant to the showerhead side of the shower arm.
Thread the showerhead to the shower arm.
Use a clean strap wrench to tighten the showerhead.
Check for proper operation.
112807-2-BB
Shower Ell
Wall Flange
Shower
Arm
Setscrew
Showerhead
4 Kohler Co.