Tabla de contenido
Publicidad
4
5
6
Distributed by Volkswagen Zubehör GmbH Printed in Germany by Volkswagen Zubehör GmbH 20.03.2012
Figure 4
1. Unfold rear lights ( 1 0) and push them downwards into
their end position.
NOTE
If the vehicle is wider than 1.91 m (max. vehicle width
without exterior mirrors), the rear lights must be moved
outwards.
- To move the lights, push the locking devices (A) together
and move the lights in direction (B).
2. Swing holders (3) and (4) forwards and move them to the
required position on carrier frame (5).
WARNING
The registration plate on the bicycle carrier must
correspond with the vehicle registration plate and must be
easily readable.
Figure 5
1. Push lower registration plate holder ( 1 ) downwards.
2. Slide registration plate into springs (2) and against
stop (3).
WARNING
Version for Austria: push stop (3) back. Registration plate
must then subsequently be pushed upwards against
springs (2).
NOTE
For narrow registration plates: use drill points (4) to secure
the registration plate.
Folding bicycle carrier
Fold bicycle carrier together in reverse order sequence.
Securing to vehicle
NOTE
The ball head on the towing hitch must be free of grease.
Figure 6
1. Unlock tensioning lever ( 11 ) using key (2).
2. Release tensioning lever ( 11 ) using lever ( 16) and swing
tensioning lever upwards (arrow B).
3. Fit bicycle carrier horizontal onto towing hitch ( 18)
(arrow A) and align parallel with rear bumper. Towing
hitch ( 18) must be guided into mounting ( 19).
4. Swing tensioning lever ( 11 ) downwards until lever ( 16)
engages (arrow B) and lock lever using key (2). Remove
key (2).
5. Shake bicycle carrier to check it is seated correctly,
remove bicycle carrier from towing hitch ( 18) and
resecure again if necessary.
6. Insert lighting connector (7) into vehicle socket ( 1 7) and
turn connector clockwise to lock it in position. Check
function of lights.
7. Remove bicycle carrier in reverse order.
GB
GB
-25-
Publicidad
Tabla de contenido
