Volkswagen LHD 3C0 071 105 B Instrucciones De Montaje página 35

7
8
9
Distributed by Volkswagen Zubehör GmbH Printed in Germany by Volkswagen Zubehör GmbH 20.03.2012
Fitting bicycles
NOTE
Only bicycles with a max. weight of 30 kg may be
transported on the bicycle carrier. See also note on page 7
(Technical details).
Risk of injury!
Fit bicycles with the assistance of a second person.
Secure bicycles against slippage/tilting.
Figure 7
1. Press lever (24) and pull out tensioning strap (22).
2. Open clamp (20) with screw (21 ) until required width of
bicycle frame is achieved.
3. Position bicycle on wheel rails (9a). Ensure spacer
holder (4) for second bicycle is positioned correctly and
that it does not touch fi rst bicycle.
4. Release clamp (20) with key ( 1 4) if necessary.
5. Position holder (3) at a suitable position on bicycle and
tighten clamp (20) with screw (21 ) then lock with key ( 1 4).
Remove key ( 1 4).
WARNING
Only secure holder to bicycle frame.
No components such as gear selector cable or brake
cables may be clamped.
Defective clamps must be replaced immediately.
6. Guide tensioning straps (22) centrally at an angle
between two wheel spokes and into buckle (23) then
clamp with lever (25) (arrow).
NOTE
The threads of the screws of the clamps must be cleaned
and lubricated at regular intervals to prevent seizure of the
rotary knob.
NOTE
Guiding tensioning straps (22) at an angle through each
bicycle wheel ensures bicycle is secured to side.
7. Using same procedure, install second bicycle (in opposite
direction to fi rst bicycle) into wheel rail (9b) and secure
with holder (4).
8. Remove bicycles in reverse order.
NOTE
The tensioning straps (22) are under extreme tension. To
release tension, press lever (24) in forcefully.
Figure 8
1. Always ensure the aluminium pipe of the holder lies fl ush
over the plastic components.
¹
Fitting third bicycle
Figure 9
1. The fi tting of the third bicycle is basically the same as
fi tting the fi rst bicycle. Fitting in opposite direction to the
previous bicycle must be observed.
2. The third bicycle is attached to the second bicycle using
the additional holder ( 1 3).
¹ Coupling carrier for 3rd bicycle (3C0.071.105 C)
GB GB
-35-