Preparation For Operation - GRAPHITE 59G383 Manual Del Usuario

CONSTRUCTION AND USE
Bench grinder is designed for light-duty works in small workshops and for individual, amateur activities
(tinkering). It is not intended for professional use. It is perfect for sharpening tools such as drills and chisels.
Grinder is not designed for continuous use and it must not be used for more than 30 minutes at a time. After
operation at full load for this amount of time, switch off the grinder for at least 30 minutes. You can install
wire brushing wheels provided that such brush can work at rotational speed equal to 2850 rpm or higher.
Use the power tool according to the manufacturer's instructions only!
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the drawing pages of this manual.
1. Eye shield
2. Eye shield (magnifying)
3. Grinding wheel
4. Side cover
5. Hole for bench fixing
6. Base
7. Switch button
8. Adjustable workrest
9. Grinding wheel cover
10. Spark shield
11. Adjustable lamp
12. Drawer for tools
13. Wheel dresser
14. Rubber cushion
* Differences may appear between the product and drawing
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1. Eye shield
2. Spark shield
3. Workrest
4. Wheel dresser
5. Bolts, screws and washers
GRINDER INSTALLATION ON A WORKSHOP BENCH
Four rubber cushions (14) help to limit vibrations and sound transfer. It is recommended to firmly fix the
grinder to a workbench or a stand with the use of two fixing points designed for such purpose. They are
located on the bench grinder base (fixing bolts are not included) and guarantee safe operation. Hole for
bench fixing (5) is located at each side of the grinder. The holes allow to use screws or bolts with diameters
up to 10 mm. When the grinder is to be installed on a metal work-bench it is recommended to put a piece
of wood under the grinder. Fixing screws should go through the wooden base. Use of wood helps to limit
vibrations.
– 2 pcs (1 piece is magnifying)
– 2 pcs
– 2 pcs
– 1 pce
– 1 set

PREPARATION FOR OPERATION

15