Intended Use - DeWalt DWE1622 Manual De Instrucciones

ENGlIsh
Voltage
Total length of cord in meters (m)
(Volts)
120–127V 0–7
220–240V 0–15
Rated Minimal cross-sectional area of the
ampere cord in meters (mm
Range
0–6A 1.0
6–10A 1.0
10–12A 1.5
12–16A 2.5
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. D
if this tool does not operate, check power supply.
COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.

INTENDED USE

This drill press is designed for professional
drilling applications.
Do NoT use under wet conditions or in presence of
flammable liquids or gases.
This drill press is a professional power tool. Do NoT let
children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
22
7–15 15–30 30–50
15–30 30–60 60–100
)
2
1.5 1.5 2.5
1.5 2.5 4.0
1.5 2.5 4.0
4.0 Not Recommended
or AC ........... alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n ........................ no load speed
o
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
WALT tools are factory tested;
e
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing the Machine
1. Assemble the feed handle.
2. Mount the drill guard.
3. Fit the lubrication system as necessary.
4. Place the machine on a clean, level and solid surface.
Remove any particles that will obstruct full contact
between the magnetic stand and the mounting surface.
5. Fit and tighten the safety chain (
Assembling the Feed Handle (Fig. A, B)
The quick-release feed handle
one simple operation both to the left and the right of
the machine.
1. Screw the handles 6 into the hub
2. Keep the button 16 depressed while inserting the hub
shaft into the hole 17 .
3. Release the button.
Fig. B
2
1
Mounting the Drill Guard (Fig. C)

WARNING: Always use the drill guard.
1. Hold the guard 9 in front of the tool holder, aligning
the slots in the guard with the holes
2. Fit the screw 18 into the hole
of the frame.
Fig. C
d
r l o a
o v e
19
, Fig. E).
15
6 can be mounted in
7 .
17
6
7
16
6
19 in the machine.
19 located in the front
9
18
18