Switching The Power On And Off - DeWalt DWE1622 Manual De Instrucciones

ENGlIsh
Fig. G
23
26
25
Setting the Speed (Fig. H)

WARNING: Do not change gears at full speed or
during use.
The machine is equipped with a two-gear selector to vary
the speed/torque ratio.
1. Rotate the gear selector tab
and shift into the desired mode.
2. Lock the selector tab back into the detent.
loW spEED aND hIGh ToRQUE: The yellow dot
should be aligned with position 1 for low speed and
high torque (holes from 32 to 50 mm).
hIGh spEED aND loW ToRQUE: The yellow dot
should be aligned with position 2, for high speed and
low torque (holes from 12 to 30 mm).
NoTE : It may be necessary to slightly turn the spindle by
hand a little to complete the gear change.
Fig. J
27
2
1
4
Adjusting the Motor Height (Fig. I)
The motor height can be adjusted to accommodate the
need for more or less bit clearance over the workpiece.
1. Loosen the motor slide bolt
key tool 29 .
2. Position the motor to the desired height.
3. Tighten the bolt firmly with the hex tool to secure the
motor in position.
Fig. I
2
1
24
2
1
out of the detent slot
4
27
27
4
2
2
1
1
25
28 with the supplied hex
28
29
OPERATION

WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
• Apply only a gentle pressure to the tool. Excessive
force does not speed up drilling but decreases tool
performance and may shorten tool life.
• It the accessory jams, stop the motor and gently
raise the accessory out of the workpiece before
resuming work.
• Always use the safety chain.
• Always use the drill guard.
Prior to operation:
• Try a few simple projects using scrap material
until you develop a "feel" for the machine.
Proper Hand Position

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the
main handle.
Switching On and Off (Fig. A, J)
In order to operate properly, the machine has to be
switched following the procedure as described below

Switching the Power On and Off

Connect the machine to the mains.
To turn the power on, press the power/magnet switch
the on position.
NoTE: Once the power is switched on the magnet will
automatically be activated.
To turn the power off, press the power/magnet switch to
the off position.
Fig. J
overload
2
to
1
1
14
3