Error Codes Sc-450 Ns - SCANMASKIN SCAN COMBIFLEX 450 Standard Manual Del Usuario

The machine is  There is a voltage drop at the
weak and might
stop when on the
ground.
The machine vi-  The grinding speed is to high  Lower the speed
brates a lot
 The tools are damaged

5.6.2 Error codes SC-450 NS

Code Descrip-
tion
A2001 Over cur-
rent
A2002 Over volt-
age
A2003 Under
voltage
7 See access table "Table 02"
64
power supply
Cause
 One of the three phases is
missing from the power sup-
ply
 There is a voltage drop at the
power supply
 The environmental tempera-
ture is too high. When the
temperature is above 40°C
(104°F) the inverter will de-
crease its maximum output
current
 The power supply has got
voltage transients
 One of the three phases is
missing from the power sup-
ply
 There is a voltage drop at the
power supply
 Inspect the fuses in the worksites
fuse box
 Inspect cables
 Measure that the main voltage is
present and at full voltage at the ca-
ble end near the machine.
 Make sure that the cable is not too
long. If the cable should be too
long, use a cable with higher rating
to a distribution box nearer the ma-
chine.
 Inspect the tools
 Change the tools if needed
Correction
 Inspect the fuses in the
worksites fuse box
 Inspect cables
 Measure that all three phases
are present and at full voltage
at the cable end near the ma-
chine
 Make sure that the cable
is not to long. If the cable
should be to long, use a ca-
ble with higher rating to a
distribution box nearer the
machine
 Inspect the ventilation fans
 Inspect the filters to the fans
 Inspect the power source
See A2001
A
www.scanmaskin.com
O
E
E
O
O
O
O
7
O
O
E
E
O
O
E