Troubleshooting - Blackstone GBK-700 1L Manual Del Usuario

9. TROUBLESHOOTING

Depending on the symptoms that you notice, you can discover the probable cause and solve the
problem.
Cause
The machine does not
work properly
The rotor does not
suction the wood
The shredded material
does not have the
same thickness
The engine does not
start or it stops
by itself
The machine gets
stuck during
use.
The engine does not
start because of the
rotor is stuck
Probable Cause
The blades are blunt
The diameter of the
branches is
too big
The space between the
blades is not
correct
Engine electric problem
No petrol left
There is no engine oil or is
low
The diameter of the
branch
is too large
Impeller or blades have
woody residue or chunks
stuck to them
41
/160
Corrective Action
Sharpen or replace the blades
Remove the branches with a
diameter wider than that
permitted.
Adjust the space to 0.5mm.
Avoid the accidental start up of
the machine. Verify that the
switch
is in the ON ¨I¨ position.
Make sure that the emergency
button is disabled.
Add fuel
Add oi (see Section 8.1.2.)
Turn off the engine and remove
the spark plug. Remove the
cap of the rotor shaft. Turn the
rotor a few degrees with a
wrench specifically designed
for this purpose.
Leave the rotor blocked using
the key. Remove the material
from the inlet tube with the
help of a stick or a tool and
restart the machine. If
necessary, change the
blades.
Engli
sh