Throttle Lockout - Ducati DBC 4600R Manual De Instrucciones

either slipping or falling into shrubbery,
branches, or bushes.
• Wear no-slip heavy duty work gloves
to improve your grip on the brush
cutter handle. Gloves also reduce the
transmission of machine vibration to your
hands.
WARNING: The cutter area
is still dangerous while the
machine is coasting to a stop
NOTE: Noise and vibration
1) The running at low speed can reduce the
noise and quiver.
2) ln order to lower noise, the brush
cutter should be operated in an open
environment.
3) The vibration can be lowered if the handle is
grabbed firmly.
4) ln order to avoid disturbing others, the
machine should be operated at daytime.
5) Wear personal protective equipment, such
as gloves and ear protection during the
operation.
6) The machine is not for professional work
and not for long time operation.
7) In order to keep the user's fitness and
prolong the machine's life, please do not
work more than 2 hours in a whole day and
don't keep working more than 10 minutes
at a time.
Machines safety equipment
WARNING! Never use a machine with faulty
safety equipment. The machine's safety
equipment must be checked and maintained
as described in this section. If your
machine fails any of these checks contact your
service agent to get it repaired.

4.1 Throttle lockout

The throttle lockout is designed to prevent
Owner's manual
accidental operation of the throttle control.
When you press the lock‐out (A) (i.e. when
you grasp the handle) it releases the throttle
trigger (B). When you release the handle the
throttle control and the throttle lockout both
move back to their original positions. This
movement is controlled by two independent
return springs. This arrangement means that
the throttle control is automatically locked at
the idle setting.
Make sure the throttle control is locked at
the idle setting when the throttle lockout is
released.
Press the throttle lockout and make sure it
returns to its original position when you release
it.
Check that the throttle control and throttle
lockout move freely and that the return springs
work properly.
See instructions under the heading Start. Start
the machine and apply full throttle. Release the
throttle and check that the cutting attachment
stops and remains at a standstill. If the cutting
attachment rotates with the throttle in the
idle position then the carburettor idle setting
must be checked. (See instructions under the
heading Maintenance).
English
33