Using The Shoulder Harness; Cutting With A Nylon Head - Ducati DBC 4600R Manual De Instrucciones

Español
Manual de usuario

8. USING THE SHOULDER HARNESS

1. Assemble and adjust the shoulder harness
and belt, as shown.
2. Adjust the shoulder-harness button, and
move the hook to your waist, then adjust
the belt(If there is a belt).
3. Hang the latch tab on the harness hook.
4. If the brush cutter does't balance, then
adjust the harness hanger, and the
handlebar, until it balances.
WARNING! The hook is situated at your right
hip, and the quick-release latch is situated at
the outside.
WARNING! Before using, please check the
shoulder harness and confirm it is OK. If in
danger, please stop the brush cutter immedia-
tely,and pull the quick-release latch tab, the
brush cutter will separate from your body.
5.To quickly detach the brush cutter from the
harness,pull the quick-release latch tab
upward;
6.Insert the latch tongue in the slot of the
quick-release latch to reattach the brush
cutter to the harness.
40

9. CUTTING WITH A NYLON HEAD

Line head rotates in a counter CLOCKWISE
direction.The CUT-OFF KNIFE will be on the
right side of the debris shield
The proper debris shield must be in place on
the unit when nylon cutting line is used. The
cutting line can flap around if too much line is
exposed. Always use the plastic debris shield
with cut-off knife when using nylon cutting
heads.
Tilting the head to the wrong side will shoot the
debris TOWARDS you.If the line head is held
flat to the ground so that cutting occurs on the
whole line circle, debris will be THROWN at
you, drag will slow the engine down, and you
will use up a lot of lines.
Use only quality nylon monofilament line of the
diameter 2.5mm. Never use wire or wire-rein-
forced line in place of nylon trimmer line. Load
your nylon line cutting head only with nylon
trimmer line of the proper diameter.