Ducati DBC 4600R Manual De Instrucciones página 38

English
Owner's manual
3.3 Fit the blade.
Three tooth blade
Take the outer flange off after release the nut,
then put the blade, outer flange, shield and
nut according to priority as below picture. Note
the blade rotation direction needs be same as
below picture. Use screw driver to hold flange
and tighten nut counter-clockwise, ensure the
nut is tightened enough.
Release blade. Use screw driver to hold flange
and release nut, the blade can be took off.
38
Warning!
Please make sure the cutting head has been
assembled correctly before use!
Note: The packaging material is made of
recycle materials. Dispose of packaging
materials in accordance with regulations.
4. Fit the bet.
According to picture
showing, fit the belt
well. Wear the belt
on the arm, and
insert the latch on
the left side into the
right lock, the belt
is fitted
You can adjust the belt board height by the two
adjusters below.
Release the belt: You can release the belt by
pull the right side belt plastic plate (as below)
until the lock pin out, and pull out the left side
latch, the belt would be release.