Dimensional Drawings; 5000Toci Sensor Installation And Start-Up - Mettler Toledo 5000TOCi Guia De Inicio Rapido

3 Dimensional Drawings

ALLOW MINIMUM CLEARANCE OF
ALLOW MINIMUM CLEARANCE OF
18 in. [457]
18 in. [457]
FOR UV LAMP REPLACEMENT
FOR UV LAMP REPLACEMENT
DO NOT
OPEN WHEN
UV LAMP
IS ON
UV LAMP
REPLACEMENT COVER
AC HIGH VOLTAGE
POWER DISCONNECT
POWER FOR
SERVICING
TRANSMITTER
CONNECTION

4 5000TOCi Sensor Installation and Start-up

Installation
Mount the 5000TOCi in an appropriate location. A minimum clearance dimension of 18" (45.7
cm) is required on the left side of the sensor for UV lamp change-out. Two plumbing connec-
tions are provided on the right side of the enclosure. The lower connection is labeled 'Sample
Inlet' and the upper connection 'Sample Outlet'. A third connection, a safety drain, is located on
the bottom of the enclosure. Figure 1 shows a typical installed configuration. The installation kit
provided includes installation tube assemblies, a sample conditioning coil and a high capacity
inlet filter. Attach the high capacity inlet filter to the sample inlet connection as shown in Figure 2.
Figure 1
Connect the 0.125" (3 mm) PTFE tubing to a sample point isolation valve (not supplied).
Warning: For inlet pressure above 85 psi (5.9 bar), a pressure regulator (Thornton p/n
6
10.05
[255.3]
7.40
7.40
[188]
[188]
Ø0.25
Ø0.25
TYP
TYP
[Ø6.35]
[Ø6.35]
[279.4]
5000TOCi Sensor Dimension Diagram
DIMENSIONS IN INCHES [mm]
Safety Drain
Atmospheric
Drain
15.0
15.0
REF
[368.3]
[368.3]
10.05
[255.3]
11.0
11
[279.4]
Process Pipe
Sample
6 to 36 in.
Drain
[15 to 90 cm]
DIMENSIONS IN
INCHES [mm]
8.05
8.05
[204.5]
[204.5]
8.8
8.80
[223.5]
DO NOT
OPEN WHEN
[223.5]
UV LAMP
IS ON
5.5
5.5
[139.7]
[139.7]
Process Pipe
Cross-Section
Isolation Valve
Regulator
(Optional)
30°-60°
Recommended
10-32
10-32
INTERNAL THD
INTERNAL THD
DRAIN BEFORE
SHIPPING
SAMPLE
OUTLET
3.26
SAMPLE
INLET
3.26
[82.8]
2.08
[82.8]
2.08
[52.8]
[52.8]
REGULATOR
REGULATOR
NOT SHOWN
NOT SHOWN
1.64
1.64
[41.6]
[41.6]