Safety Instructions - Mettler Toledo 5000TOCi Guia De Inicio Rapido

1 Safety Instructions

This manual includes safety information with the following designations and formats.
Definition of equipment and documentation symbols and designations
WARNING: POTENTIAL RISK OF ELECTRIC SHOCK.
CAUTION: possible instrument damage or malfunction.
NOTE: Important operating information.
On the instrument indicates: There is alternating current present.
The following is a list of general safety instructions and warnings. Failure to adhere to these
instructions can result in damage to the equipment and/or personal injury to the operator.
– The 5000TOCi Sensor should be installed and operated only by personnel familiar
with the sensor and who are qualified for such work.
– The 5000TOCi Sensor must only be operated under the specified operating conditions.
– Repair or service of the 5000TOCi Sensor must be performed by authorized, trained
personnel only.
– If this equipment is used in a manner not specified by the manufacturer, the protection
provided by it against hazards may be impaired.
– Use only factory documented components for repair. Mettler-Toledo accepts no
responsibility for damage caused by unauthorized modifications to the sensor.
– Follow all warnings, cautions, and instructions indicated on and supplied with this product.
– Protective covers must be in place unless qualified personnel are performing
maintenance.
– Protective covers must be in place at all times during normal operation.
– Install equipment as specified in this instruction manual. Follow appropriate local and
national codes.
– Prior to shipping sensor back to the factory for repair or re-calibration, water MUST be
drained from sensor to avoid damage due to freezing.
WARNINGS:
– Installation of cable connections and servicing of this product require access
to shock hazard voltage levels. Switch or circuit breaker shall be in close
proximity to the equipment and within easy reach of the OPERATOR; it shall
be marked as the disconnecting device for the equipment.
– Main power must employ a switch or circuit breaker as the disconnecting
device for the equipment. Electrical installation must be in accordance with
the National Electrical Code and/or any other applicable national or local
codes. Safety and performance require that this sensor be connected and
properly grounded through a three-wire power source.
– Ozone gas (O
normal operation. The smell of ozone may be apparent when opening the
4
) is generated inside the 5000TOCi Sensor enclosure during
3