Engine Oil Change; Air Filter Maintenance - Pramac Pmi3000 Manual Del Operador

user has right tools or mechanical expert. If do the self inspection, user must
contact with local agent in advance.

7.2 Engine oil change

When the engine is warm, engine will be empty of oil easier and faster, see figure 12.
1. Screw off and take out dipstick.
2. Disassemble oil drain bolt (or open oil drain valve, if there is ), exhaust scrap oil, then
tighten (or close oil drain valve, if there is).
3. Fuel recommended oil and check the oil level.
4. Tighten dipstick.
Oil capacity：0.52L
 In order to meet environmental requirements, we suggest that you put the scrap oil
into a sealed container and send it to local service station or recycling center. Don't pour
it on the ground or in the trash.

7.3 Air filter maintenance

Dirty air filter will block air into the carburetor. In order to prevent the carburetor breakdown,
please maintain the air filter regularly. If used in the dirty areas, need more frequent
maintenance.
 Do not use gasoline or low flash point solvents to clean the generators, because
they are flammable and explosive under certain conditions
 Never run the generator without air filter, otherwise engine will wear quickly.
1. Screw off the screw on the bottom of the air filter and disassemble the air filter cover.
2. Take out the filter element, use compressed air to blow or knock the dust out from filter
element inside, if seriously dirty, change it.
3. Install the filter element back to the Air filter cartridge, replace the air filter cover and
tighten the screws.
Figure 12 Change engine oil
16