Heath Zenith SL-6200 Manual De Instrucciones página 3

Note: The top button is factory set to our standard default
code (5, 6, 7). The bottom button is factory set to a different
code. Follow the instructions below to set the code and
tune for each chime. Verify the push button codes match
the respective chime code.
WARNING: Disconnect chime unit from power source
before opening code access door. Close door and replace
screw before reconnecting to power.
The push button and chime communicate by using a code that
can be changed by removing and/or adding jumpers on both the
push button and chime. The code is factory set; however, there
are 128 selectable codes that allow you to expand your system
and prevent outside interference. Other wireless products may
cause interference and the system may not function properly.
Follow the instructions below for setting a new code.
1. Unplug wireless chime (if applicable).
2. Open the cases and locate the jumpers on both the push
button and chime (See illustration on page 5).
. The push button and chime both have eight different jumper
locations. The jumper positions 1 through 7 are used for
setting the code.
4. To change the code, add and/or remove jumpers as needed.
It is recommended to only change one jumper at a time and
then check to see if system is functioning properly.
Note: Jumpers in positions 1 through 7 must be exactly
the same for both the push button and chime for this
system to function.
598-1144-02
Code and Tune Settings
Code Settings
--