Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
16.1.2 Starting with a warm Engine
16.2 Switching off the machine
1. Release the throttle.
2. Set O
-O
N
FF
16.3 Turning the Handle
16.4 Recommendations for Cutting
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
ZI-BHS605
switch (A) to position "0" (O
To give you the best and most ergonomic way to trim your hedge,
the handle can be rotated 90 degrees to the right or left - see
illustration on the left.
Notice:
Do not press on the throttle when turning the handle!
Procedure:
Press the throttle lock (1) on the top of the rear handle. Then push
the locking handle (2) downwards while simultaneously turning the
handle to the left or right – see illustrations on the left.
Only accelerate as much as necessary.
Hold the hedge trimmer at an angle of 5-10 degrees to the
hedge (see illustration on the left).
→ This makes cutting easier and the result is better.
1. Set the O
-O
N
(O
).
N
2. Move the choke lever (C) to run position
(C2) = closed.
3. Pull start rope (D) until the engine is
running.
).
FF
OPERATION
switch (A) to position "I"
FF
22
Publicidad
Tabla de contenido
