Maintenance; Maintenance Schedule; Measures Before Starting; Cleaning The Air Filter - Zipper Maschinen ZI-BHS605 Manual Del Usuario

17

MAINTENANCE

Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always switch off the machine for conversion,
adjustment, cleaning and maintenance work and secure it against unintentional
recommissioning.
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
If you are unable to carry out necessary maintenance work properly and/or do not have the
required training, always consult a specialist workshop to get the problem fixed.
17.1

Maintenance schedule

The type and degree of machine wear depend to a large extent on the operating conditions. The
following intervals apply when the machine is used within the specified limits:
Assembly
group/component
Fuel leak
Fuel tank, air filter, fuel
filter
Spark plug
Airfilter
Sword, blades
Gear box
Bolts, screws, nuts

17.2 Measures before Starting

Remove leaves, branches and dirt from the machine.

Check the machine for loose or missing parts.

Fasten loose parts.

Check the air filter for contamination.

Check the machine for leaks in the fuel system.


17.3 Cleaning the Air Filter

A dirty air filter makes it difficult to start the engine and reduces the engine power.
Procedure:
1. Loosen the wing nut on the air filter housing, remove the cover and check that there is no
dirt in the filter.
2. If necessary, clean the air filter in warm soapy water.
3. Allow the air filter to dry completely.
4. Then soak the air filter with 2-stroke engine oil.
5. Squeeze out excess oil.
6. Insert the oil-soaked filter.
7. Mount the air filter cover and tighten the wing nut.
Signs indicating a necessary air filter change:
- Engine power decreases, at the same time fuel consumption increases
- Oil consumption increases
- Starting the engine becomes more difficult
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BHS605
WARNING
Before
What to do?
starting
wipe up spilled fuel
immediately
check and clean
cleaning and
adjusting the spark
plug head
clean
check and clean
check and lubricate
tighten, replace
After xx operating
hours
25 50
✔
✔ ✔
✔
✔
✔
✔
✔
MAINTENANCE
Remark
100
replace if
necessary
Distance 0,6-0,7
mm
replace if
necessary
grease during
and after use
✔
23