Hilti DD 150-U Manual De Instrucciones página 47

Gear indicator
Hand-guided operation
Stand-guided mode
Hole-starting mode is
active
Remaining running time in
hole-starting mode
Hole-starting mode deacti-
vated
Hole-starting mode cannot
be activated
Drilling performance
indicator: Contact pressure
is too low
*2204400*
The diamond core drilling machine is running under no load. The display
helps ensure that the gear engaged is suitable for the diamond core bit
used. At top left, the display shows the gear engaged and in the center,
the recommended core bit diameter range in millimeters and inches for this
gear.
• The recommended core bit diameter range varies depending on whether
the diamond core drilling machine is operated in the hand-guided or
stand-guided mode.
The continuous-running lock is deactivated. The device is in the hand-
guided mode.
• This information is shown in the display only for a few seconds.
The continuous-running lock is activated. The device is in the stand-guided
mode.
• This information is shown in the display only for a few seconds.
The diamond core drilling machine is switched off or running under no load.
This function makes it possible to start holes with low vibration when using
large-diameter core bits. This function can be deactivated at any time by
pressing the button again.
• This information is shown in the display only for a few seconds.
The diamond core drilling machine is drilling and the hole-starting mode is
active. The display shows the time remaining until the diamond core drilling
machine automatically switches off.
• To protect the diamond core drilling machine, hole-starting mode is
switched off automatically after a maximum of 2 minutes.
This information is shown in the display only for a few seconds.
Hole-starting mode has been deactivated. Speed and power of the dia-
mond core drilling machine increase and drilling can proceed
• This information is shown in the display only for a few seconds.
The diamond core drilling machine is drilling. The button for activating hole-
starting mode was pressed while the diamond core drilling machine was
under load or was in cool-down mode.
• This information is shown in the display only for a few seconds.
The diamond core drilling machine is drilling and the hole-starting mode
is not activated. The information displayed helps ensure that the diamond
core drilling machine is being operated in the optimal range.
• Background color: Yellow.
Contact pressure is too low. Increase the contact pressure.
2204400 English 39