Hilti DD 150-U Manual De Instrucciones página 49

Connection interrupted
Analysis of running time
Analysis of operating
behavior
Analysis of drilling direction
Analysis of gear selection
Analysis of use
Connected devices
Start connection setup
Gear selector not latched
*2204400*
An existing Bluetooth connected to a device or accessory has been inter-
rupted.
The display shows drilling time (diamond core drilling machine actually
drilling) at the top and operating hours (diamond core drilling machine
switched on) at the bottom. Both figures are shown in hours, minutes and
seconds.
To reset drilling time and all other analysis data, press the
hold it down for a few seconds.
• The information shown on the display disappears automatically after a
few seconds or when you press the
•
Pressing the again takes you to the next analysis data.
This display shows contact pressure during drilling time as a percentage
(%). This enables user behavior to be optimized.
• The information shown on the display disappears automatically after a
few seconds or when you press the
• Pressing the again takes you to the next analysis data.
This display shows an evaluation of the drilling directions in %.
• The information shown on the display disappears automatically after a
few seconds or when you press the
•
Pressing the again takes you to the next analysis data.
This display shows an evaluation of the duration of use of the respective
gear in %. The arrow always points to the gear with the highest rate of use.
• The information shown on the display disappears automatically after a
few seconds or when you press the
•
Pressing the again takes you to the next analysis data.
This display shows the use of the diamond core drilling machine in the
hand-guided and in the stand-guided mode in %.
• The information shown on the display disappears automatically after a
few seconds or when you press the
•
Pressing the again takes you to the next analysis data.
This display provides an overview of all devices and accessories connected
to the diamond core drilling machine.
• The information shown on the display disappears automatically after a
few seconds or when you press the
• Pressing the again takes you to the next analysis data.
Start connection setup process at the diamond core drilling machine first
and then at the device or accessory you want to connect.
To start the process of establishing the connection, simultaneously press
the and buttons and hold them down for at least 1 second.
• The information shown on the display disappears automatically after a
few seconds or when you press the
•
Pressing the again takes you to the next analysis data.
The gear selector is in an intermediate position or is not correctly latched.
Operate the gear selector until it latches completely.
2204400
button and
button again.
button again.
button again.
button again.
button again.
button again.
button again.
English 41