Publicidad
Section 3
Install Wiper Motor into Rear Glass
Step 1
512.61
Step 1
Step 1
From the inside of the glass, place the
wiper motor so that the wiper output
shaft passes through the lower left
hole.
Replace the rubber washer, cupped
washer, and nut that you set aside
earlier.
Hand-tighten the 3/4" nut at this point.
P6 - 54858 - Rev. B 0515
Hardware
3/4" Deep-Well
Socket
Screw Cap
Qty. 1
Part # 514.65
Installation Instructions - Trektop PRO Rear Window Wiper Kit
#10-32 x 1.25
Screw
Qty. 1
Part # 316.93
Bushing
Qty. 1
Part # 514.01
Page 6
Step 2
Step 2
Place bushing into lower right hole in
glass, and then partially insert #10
screw and screw cap.
Screw should only be part way
through the hole in the flange of the
wiper motor inside the glass.
© 2015 Bestop, Inc.
Publicidad
