Deltafox DP - CAG 2015 Traducción Del Manual De Instrucciones Original página 31

high as the highest rotation speed
indicated on the electric tool. Acces-
sories that run faster than the allow-
able speed can break and fly apart.
• The outside diameter and thickness
of the attachment tool must corre-
spond to the dimensions indicated
for your electric tool. Attachment
tools which are wrongly dimensioned
cannot be sufficiently shielded or con-
trolled.
• Attachment tools with threaded at-
tachment must fit the threading of
the grinding spindle exactly. For at-
tachment tools which are mounted
through a flange, the diameter of the
hole in the attachment tool must fit
the mounting diameter of the flange.
Attachment tools which cannot be pre-
cisely attached to the electric tool turn
unevenly, vibrate very strongly and can
ultimately lead to a loss of control.
• Never use damaged attachment
tools. Check attachment tools such
as grinding discs for chipping or
cracks, grinding plates for cracks,
wear or strong abrasion and wire
brushes for loose or broken wires
before using them. If the electric
tool or the attachment tool falls off,
check whether it is damaged or, use
an undamaged attachment tool. If
you have checked the attachment
tool and attached it, keep yourself
and any nearby persons beyond the
level of the rotating attachment tool
and allow the device to run for 1
min. at the highest rotational speed.
Damaged tools usually break during
this test period.
• Wear personal safety equipment.
Depending on the application, use
full face shields, eye protection or
safety goggles. In so far as it is ap-
propriate, wear dust masks, ear
protection, gloves or special aprons
which keep small grinding and ma-
terial particles away from you. Eyes
should be protected from the foreign
matter which can be caused to fly dur-
ing the various applications. Dust or
breathing masks should filter the dust
that is created during operation. If you
are exposed to loud noise for a long
time, you may suffer hearing loss.
• Ensure that other people are at a
safe distance to your working area.
Anyone who enters the working area
should wear personal protective
equipment. Broken bits from the piece
being worked or broken attachment
tools can fly away and cause injuries
even beyond the direct working area.
• Hold the electric tool only by the
insulated gripping surfaces when
performing work in which the cut-
ting tool may come into contact with
hidden wiring. Contact with a live wire
can also cause a charge in metal parts
of the device and result in an electric
shock.
• Keep the cord away from the rotat-
ing attachment tool. If you lose con-
trol of the device, the power cord can
become separated or caught and your
hand or arm may be pulled into the ro-
tating attachment tool.
• Never put the electric tool down be-
fore the attachment tool has come
to a full stop. The rotating attachment
tool can come into contact with the
surface upon which it is set, whereby
you could lose control of the electric
tool.
• Never allow the electric tool to run
whilst you are carrying it. Your cloth-
ing may accidentally come into contact
with the rotating attachment tool and
GB
31